MIL-STD865-D (USAF) - Selective (Brush Plating) Electrodeposition
MIL-STD-2197 (SH) Brush Electroplating on Marine Machinery
AMS-2451B Plating Brush General (Specific Deposits)

Web site contents © Copyright Ultra Engineering 2009, All rights reserved.

Safety Procedures
All Operators Must Read Material Safety Data Sheets (MSDS) Before Proceeding

• Eye Protection - Safety Glasses or Full Face Mask Must be worned at all Times
  
• Respiratory Protection - Respiratory Mask to be worned at all Times
  
• Skin Protection - Plastic latex gloves to be worned at all Times
  
• Clothing Protection - Plastic Apron, Impervious Boots as Required by conditions

In Case Of A Spill - General For All Solutions

• Isolate hazard area and keep people away
  
• Eliminate all sources of ignition
  
• Provide maximum ventilation
  
• Do not release into soil, sewers or rivers, neutralize with soda ash or lime
  
• Wear proper protective equipment
  
• Carefully mop spill and triple rinse with water into a suitable plastic container
  
• Dispose into Plating Solutions Waste Drum or suitable container
  
• If Eye Contact - Flush eyes with clean water for 15 minutes. Consult Doctor
  
• If Skin Contact - Flush with clean soapy water for 15 minutes
  
• Inhalation - Remove to fresh air location and loosen clothing
  
• Ingestion - Do not induce vomiting, drink large quantities of water or milk. Consult Doctor
  
• Ingestion of GOLD Solution - Induce vomiting, drink large quantities of water. Consult Doctor

Wash Hands after Use.
 Eating or Drinking is Not Permitted in Plating Area.